9
SCENES
Programming a Scene
1) Enter program mode (See Enabling Program Mode)..
2) Check the blackout key and verify that the LED is not lit, if it is, press it once to exit blackout mode.
3) Verify that the speed and fade time sliders are positioned at zero.
4) Press the SCANNER button corresponding to the unit wish to control. You may control more than one
scanner at time by pressing the button corresponding to the scanners) you wish to program.
5) Move the faders and joystick to the desired position. If necessary, you may select page B to control
channels 9-16.
6) Tap the BANK Up/Down button to choose the bank you want to store this scene into. There are a total of
30 banks you can select, you may store up to 8 scenes in each bank.
7) Once all scanners are programmed into the desired position for the scene, tap the MIDI/Rec button to
program this scene into memory.
8) Tap the SCENE button you wish to store your scene into. All LEDs will flash three times signifying this
operation. The LCD readout will show the bank and scene.
9) To unselect the scanner(s) you have been programming and switch to another, simply press the button of
the scanner you have been programming again, deselecting it, and select another scanner.
10) Repeat steps 2-7 until all scenes have been programmed.
11) If you don't intend to continue programming at this time, press and hold the PROGRAM button for three
seconds to exit program mode. The LED will go out indicating this selection.
Example Scene Program
1) Program Enable
2) Tap the Scanner 1 button to turn on its fader control.
3) Verify that the page select is set on page A, if not press the PAGE SELECT button to select page A.
4) Move the first and second faders all the way up-to their maximum value position.
5) Select BANK 1 using the BANK Up/Down buttons.
6) Press the MIDI/Rec button.
7) Tap SCENE 1 to store the first scene.
8) Repeat steps 4-7, until all scenes have been programmed into BANK 1.
9) Tap the SCANNER 1 button to turn off the fader control.
10) When finished, disable PROGRAM mode. You can now manually tap through you have just
programmed.
Editing a Scene
1) Program Enable.
2) Press the BANK Up/Down button to select the bank containing the scene you wish to edit.
3) Select the scene you wish to edit by tapping its SCENE button.
4) Use the faders and/or joystick to make the desired adjustments to the scene.
5) Once you have completed the changes, tap the MIDI/Rec button.
6) Tap the SCENE button that corresponds to the scene you're editing. This will override the existing scene.
Be sure to select the same scene in steps 3 and 6, otherwise you may accidentally record over an existing
scene.
Copy Scanner Settings
This setting allows you to copy the settings from one scanner to another.
1) Press and hold down the scanner button you wish to copy.
2) While holding down the button, tap the button of the scanner you wish to copy the settings to.
(16 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals