SHOWTEC 30711 Matrix Blinder 5x5 User's Guide download pdf (Page 10)

Installation

Installing the Lamp

The Showtec Matrix Blinder uses the Par 30 E27 Spot (ordercode 80120) bulb as manufactured by all

popular manufacturers. Use only the appropriate lamp for your unit.

Note that, product versions that use other lamps, may be offered in the future. Check your product

specification label for information.

Always disconnect from electric mains power supply before changing lamps.

The lamp has to be replaced when it is damaged or deformed due to the heat.

Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the

device was not designed for.

Damages caused by non-observance are not subject to warranty.

Procedure :

1. Gently turn the light bulb counter-clockwise, when a lamp is damaged/broken.

2. Read lamp instructions.

3. Insert the new lamp into the small E27 screw socket.

4. Fasten the light bulb snugly by turning it clockwise.

Fig. 3

Set Up and Operation

Follow the directions below, as they pertain to your preferred operation mode.

Before plugging the unit in, always make sure that the power supply matches the product specification

voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 34 35

No comments

SHOWTEC 30711 Matrix Blinder 5x5 User's Guide Page 10