SHOWTEC ORDERCODE 30645 User's Guide download pdf (Page 13)

Adjusting the yoke position

The device provides multi-positioning capabilities within its yoke for overall fixture height and angle.

Setting the fixture height within the yoke

The device has a two-position yoke for modifying the overall height in which the fixture is mounted

(Fig 14). To change the height position, do the following:

1. Remove the yoke locking knobs, washers, and hex bolts from either side of the fixture.

2. Raise or lower the fixture to the desired position within the yoke.

3. Replace the yoke's hex bolts.washers, and locking knobs.

4. Tighten the yoke knobs to secure the fixture in position.

Fig. 14

Setting the angle within the yoke

1. Loosen the yoke locking knobs. (Do not remove them.)

2. Tilt the fixture to the desired position (Fig. 15).

3. Tighten the yoke locking knobs to secure the fixture in position.

Fig. 15

Cleaning

Please follow the following recommendations when cleaning and inspecting lenses and

reflectors:

Do not use glass or window type cleaners on lenses (glass or polymer) or reflectors.

Do not use abrasive materials such as steel wool.

Replace lenses if they contain visible damage (cracks or deep scratches) that may impair their

effectiveness.

1 2 ... 8 9 10 11 12 13 14 15 16 17

No comments

SHOWTEC ORDERCODE 30645 User's Guide Page 13