SHOWTEC Phantom 250 Spot User's Guide download pdf (Page 11)

Set Up and Operation

Follow the directions below, as they pertain to your preferred operation mode.

Before plugging the unit in, always make sure that the power supply matches the product specification

voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.

One Phantom

1. Fasten the moving head onto firm trussing (Use a 30-kg rated or stronger C-clamp fastened onto the

Phantom ). Leave at least 1 meter on all sides for air circulation.

2. Plug one end of the electric mains power cord into the IEC socket on the unit.

Then plug the other end of the cord into a proper electric power supply socket.

3. Turn on the music. If Audio is set, then the fixture will react to the beat of the music.

Multiple Phantoms

1. Fasten the effect light onto firm trussing (Use a 30-kg rated or stronger C-clamp fastened onto the

Phantom ). Leave at least 1 meter on all sides for air circulation.

2. Use a 3-p XLR cable to connect the Phantoms and other devices.

The pins:

1. Earth

2. Signal -

3. Signal +

3. Link the units as shown in (figure 5), Connect a DMX signal cable from the first unit's DMX "out" socket to

the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.

4. Supply electric power: Plug electric mains power cords into each unit's IEC socket, then plug the other

end of the mains power cord into proper electric power supply sockets, starting with the first unit.

Do not supply power before the whole system is set up and connected properly.

5) Only one fixture can be the master.

Multiple Phantoms Set Up

DMX-Set up

Master/Slave Set up

Fig. 5

Note : Link all cables before connecting electric power

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 24 25

No comments

SHOWTEC Phantom 250 Spot User's Guide Page 11