SHOWTEC Indigo 150 LED User's Guide download pdf (Page 9)

Backside

Fig. 2

3 4 5 6

3) IEC power connector + Fuse 1,5A 250V

4) On/Off

5) DMX signal connector (IN) 3-pin

6) DMX signal connector (OUT) 3-pin

Installation

Remove all packing materials from the Indigo 150 LED. Check that all foam and plastic padding is

removed. Connect all cables.

Do not supply power before the whole system is set up and connected properly.

Always disconnect from electric mains power supply before cleaning or servicing.

Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Follow the directions below, as they pertain to your preferred operation mode.

Before plugging the unit in, always make sure that the power supply matches the product specification

voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.

Connect the device to the main power supply. The device can be music-controlled by its built-in

microphone.

Control Modes

There are 4 modes: • Stand-alone (built-in programs)

• Sound-controlled

• Master/Slave

• DMX512 (12 Channels ADVANCED or 9 channel BASIC)

One Indigo (Built-in Programs)

1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.

2. When the Indigo is not connected by a DMX-cable, it functions as a stand-alone device.

Please see page 14 for more information about the built-in programs.

One Indigo (Sound-control)

1.Plug the end of the electric mains power cord into a proper electric power supply socket.

2. Turn on the music. If the device is set to sound-control, then the Indigo will react to the beat of the

music. Please see page 14 for more information about the sound-control options.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

No comments

SHOWTEC Indigo 150 LED User's Guide Page 9